9.1 DIGIUM WILDCARD X100P FXO PCI CARD
This card allows you to connect a POTS (plain Old Telephone System) line to your Asterisk@Home box (See Notes for Patch information).
If this card is added after Asterisk has been configured, it may be necessary to configure it by using the zaptel card auto-config utility so the correct zaptel driver will be set up. To do that, enter the following from the command line.
rebuild_zaptel (restart after each command)
genzaptelconf (see notes re command switch)
Next go into the AMP web interface to create a trunk and you will notice that there is already a trunk called ZAP/g0. You need to edit this.
1. 2. 3. 4. 5.
Enter the phone number for you pots line in the Caller ID field Enter 1 for Maximum channels Set a dial rule you want for this trunk
Select an outbound dial prefix to select this trunk when dialing Set the Zap Identifier to 1 (the default is g0)
Once the card is configured, you must add a route for Incoming Calls or asterisk will not answer this line
Click on Incoming Calls in AMP and set up an incoming route. To make outbound calls you will need to set an outbound route as well.
If you have this card installed, you will need to edit the
following files; zapata.conf, zaptel.conf and modules.conf for AAH 1.x or modprobe.conf for AAH 2.x. The last 2 files live in the /etc directory – use a text editor to edit them.
9.1.1 zapata.conf
Under [channels] edit the following lines:
[channels]
busydetect=yes
busycount=6
For my installation to function correctly, I have also changed the following setting to obtain a good compromise on volume/echoing:
rxgain=10.0 (you may have to experiment a little with